NSK Rodamientos De Bolas Autoalineables
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
Self-Aligning Ball Bearings are ideal when the alignment of the shaft and housing is problematic and the shaft may bend. The outer ring has a spherical raceway with its center of curvature coinciding with the bearing. This allows the axis of the inner ring, balls and cage to deflect to some extent around the bearings center. The axial load capacity is low since the contact angle is small. Under normal loads, the permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees).
Product Features and Benefits:
- High quality steel - Ultra clean steel helps extend bearing life extended up to 80%
- Pressed steel and polyamide cages available
- Advanced Grease Technology - Lubricants that can extend grease life and performance
- High grade balls - Smooth and quiet operation even at high speeds
- Super Finished Raceways - Refined to minimize noise and improve lubricant life and distribution
- Sealed versions are available
- 60 mm x 110 mm x 28 mm NSK 2212 Rodamientos De Bolas Autoalineables
- 60 mm x 110 mm x 28 mm
- 140 mm
- 90 mm x 190 mm x 64 mm NSK 2318 K Rodamientos De Bolas Autoalineables
- 90 mm x 190 mm x 64 mm
- 25,987 mm
- 75 mm x 130 mm x 25 mm NSK 1215 Rodamientos De Bolas Autoalineables
- 52,388 mm
- 30,162
- 80 mm x 140 mm x 33 mm NSK 2216 K Rodamientos De Bolas Autoalineables
- 80 mm x 140 mm x 33 mm
- NJ3313